Rear axle?

[jawa69]

Hi guys I have v-max lowering kit and have just had some alloys fit with a 35 offset. The sliding door is rubbing rear wheel ( I do have a carpet lined panel on the door so slightly thicker than normal panel). However when I have put a straight edge across wheel the offside wheel stands proud of the arch by 5mm but 11mm on the near side. Advice please as if it was equal on both sides my rubbing door would be solved. Thanks for your comments in advance. Jawa69

[dooka]

You can either use washers as spacers behind the slider, easy job to do or you will need a higher offset wheel or a narrower wheel or you will need to remove your ply..