MK5 Golf GTI seats into 2007 Caddy

P33l · Post by **P33l** » Thu Jan 31, 2019 10:24 am

I have been offered by a friend some interlagos Mk5 Golf GTI seats from a 3 door that has been turned into a track car. Are these a direct fit to the caddy? I use it for camping alot and need to move & tilt the front seats to provide more leg room so this 3door sliding seat would make my life a million times easier and I do love that tartan pattern.
Thanks
Al

karlos0891 · Post by **karlos0891** » Thu Jan 31, 2019 12:05 pm

if you get touran bases with the touran bolts they will bolt in if you use caddy bases you have to drill new holes into the bases for two bolts

Sent from my iPhone using Tapatalk

P33l · Post by **P33l** » Thu Jan 31, 2019 2:55 pm

Thanks for the response. I think I go down the Caddy bases route as I already have them so saves more cost and its not like the caddy seats would be used again.
I will feedback once I have done it.
Thanks

brooneye · Post by **brooneye** » Thu Jan 31, 2019 4:31 pm

I believe by using the caddy bases the seat will sit lower

Sent from my iPhone using Tapatalk

Caddyluv · Post by **Caddyluv** » Thu Jan 31, 2019 4:38 pm

0.4mm. But technically yes.

well that’s what I was told.

Sent from my iPhone using Tapatalk

P33l · Post by **P33l** » Thu Jan 31, 2019 10:41 pm

Bit lower would be better I think. Is it fairly straight forwards just unbolt and bolt on? I know there are two holes that need drilling but other than that anything else I need to know?
Thanks in advance
Al

peely · Post by **peely** » Fri Feb 01, 2019 4:44 am

This is not relative to the seats question at all so sorry to you all , but just intrigued as to your forum name AL, .. p33l as I’m Peely would you be Peel ??? And p33l is my number plate

karlos0891 · Post by **karlos0891** » Fri Feb 01, 2019 10:47 am

if you go touran bases so long as you have the 4 bolts from either the golf or the touran for the seats to the base then its all bolt in as the caddy has smaller diameter bolts i believe. but if you use the caddy base then its two front bolts bolt straight in then drill for the rears i believe then use a nut and bolt per side. but touran bases require no drilling

Sent from my iPhone using Tapatalk

P33l · Post by **P33l** » Wed Feb 13, 2019 12:26 pm

Peely you are correct. Whats your plate as I did try and buy one some years back very similar but decided to go for something else instead. Long lost cousins perhaps??

peely · Post by **peely** » Thu Feb 14, 2019 11:39 am

P33lyf Peel. And the f for Fred my middle name

E-Bagge · Post by **E-Bagge** » Tue Feb 19, 2019 12:29 am

Here's how to change the seats.

viewtopic.php?f=22&t=37320

CADDY2K.com