CADDY2K.com

I could really do with help on installing my rear seat belts, anyone have some clear pictures of them installed, mine are from a caddy life, also what spreader plates did you use, I would search but I don’t have enough post, hope some one can help

Where abouts in the rear as normally just go by the sliding door i think but i had mine installed in the rear tail light pillars had to have a threaded nut welded to a plate and welded and rivoted into the pillar in two places on mine will post some pics of where mime is installed

Sent from my SM-G950F using Tapatalk

Just behind the sliding door, just want to see if I’m looking at the right spot, especially the lower belt.


Sent from my iPhone using Tapatalk

I thought these fixings would be in all maxis?

Mines just a swb, I’m fitting the caddy life seats, I can’t believe the seat belt anchor points are not installed from factory on all caddy

Hi
Does anyone know the distance that the middle row seat belt anchors should be fitted?

I’ve now sold the caddy I installed the rear seats into so I can’t take pics for u but
I purchased all my seats and hardware from Sirus
You need to drill into the metal partition
I then used masking tape to hang the spreader plate down behind whilst threading seat belt bolt through so you don’t keep dropping it lol
It’s a bit of a fiddle but if I managed any one can do it

Thanks, I’ve now in stalled the seats and seat belts


Sent from my iPhone using Tapatalk

Hi
anyone know what brackets go under the floor(under the tank to secure the rear brackets?