Reverse camera help
-
- 200BHP+
- Posts: 206
- Joined: Mon Jan 04, 2021 1:35 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Reverse camera help
I took ignition live from behind the head unit (the cable had 12v ignition live written on it) . I assume this will be ok?
I will try the relay tomorrow and let you know how I get on.
Thanks again for the help
I will try the relay tomorrow and let you know how I get on.
Thanks again for the help
- the swan fiend
- Hyper Poster
- Posts: 5131
- Joined: Sat Feb 18, 2017 10:52 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Reverse camera help
Was that from the radio loom?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Rescue me from the swans in me
- Handyandy
- Hyper Poster
- Posts: 535
- Joined: Wed Dec 18, 2019 9:47 am
- Engine size/power: 1.6 CR TDI (75bhp)
- Location: Flintshire North Wales
Re: Reverse camera help
I had a switched live for the camera which should be your yellow wire connected to the reverse lights and the live wire red to a permanent live so you can select it from your display
Beluga blue caddy remapped to 145ish side window and bonnet deflector lowered and 18" calibre rims on 225/40/18
-
- 200BHP+
- Posts: 206
- Joined: Mon Jan 04, 2021 1:35 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Reverse camera help
@the swan fiend . Yeah from radio loom. Should I not of taken it from there ?
- the swan fiend
- Hyper Poster
- Posts: 5131
- Joined: Sat Feb 18, 2017 10:52 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Reverse camera help
I’m not sure mate to be honest. I think to be sure go from the fuse box. However, I’d hope someone with more knowledge could confirm.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Rescue me from the swans in me
-
- Hyper Poster
- Posts: 2401
- Joined: Mon Oct 19, 2020 7:58 pm
Re: Reverse camera help
On a kenwood the yellow wire is for vision, the purple wire is the switching/signal wire. Do not inject power into the yellow wire.
The radio should be fused at the fuse box so taking the live from the loom should be OK, they don't use much power.
The radio should be fused at the fuse box so taking the live from the loom should be OK, they don't use much power.
2016 Starlight blue highline 2.0 tdi - stainless side bars - DubUnit remap 190 bhp ish - st x lowering kit - golf R cadiz 18" wheels - rear wiper delete - ProVan600 interior led light - red painted calipers - Kenwood headunit - sequential side repeaters - vcds hex net pro
- AlwynMike
- Caddy2k Groupie
- Posts: 45
- Joined: Sat May 08, 2021 7:36 pm
- Engine size/power: 1.6 CR TDI (102bhp)
- Location: Near Lincoln
Re: Reverse camera help
I found out the hard way about the reverse light pulse feed....its full voltage for 10 seconds or so, then pulsing. I had fitted a relay in the feed to supply the reverse camera and add on screen.
I fitted a capacitor across the relay coil feed that smoothed the voltage enough so the relay operated fine. Can't remember the value of the capacitor now...and its buried behind the side trim!
I fitted a capacitor across the relay coil feed that smoothed the voltage enough so the relay operated fine. Can't remember the value of the capacitor now...and its buried behind the side trim!
-
- 200BHP+
- Posts: 206
- Joined: Mon Jan 04, 2021 1:35 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Reverse camera help
So I took the rear light out, traced the cable for the reverse light to the front of the van. Connected my reverse sensor cable from the back of the head unit to it and it is now working.
I forgot to mention yesterday I fitted a fuse to the power cable to the camera as per the instructions.
Thank you all again for the help
I forgot to mention yesterday I fitted a fuse to the power cable to the camera as per the instructions.
Thank you all again for the help
- the swan fiend
- Hyper Poster
- Posts: 5131
- Joined: Sat Feb 18, 2017 10:52 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Reverse camera help
Glad you sorted it mate. It’s a learning curve isn’t it?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Rescue me from the swans in me
-
- 200BHP+
- Posts: 206
- Joined: Mon Jan 04, 2021 1:35 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Reverse camera help
Yeah I’ve learnt never to touch anything electrical again
I’m just glad people on here are so helpful as I would still be sat with the van in a million bits without the help
I’m just glad people on here are so helpful as I would still be sat with the van in a million bits without the help
- the swan fiend
- Hyper Poster
- Posts: 5131
- Joined: Sat Feb 18, 2017 10:52 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Reverse camera help
Haha, it’s crossed my mind. Mine took me a week of messing to get it working, so you’re a pro in my book
Yeah it’s a great place for help.
Sent from my iPhone using Tapatalk
Yeah it’s a great place for help.
Sent from my iPhone using Tapatalk
Rescue me from the swans in me