Page 1 of 1

turbine wheels

Posted: Wed Nov 24, 2021 1:37 am
by Cabman
Hi guys im thinking of upgrading the wheels on my 2012 caddy i need to know if a set of scirocco 18 turbines would be a straight fit and speedo be ok

turbine wheels

Posted: Wed Nov 24, 2021 2:09 pm
by Vertex92
Hey mate

Literally just fitted a set of the scirocco interlagos onto mine and when straight on. As long as the studs and pcd match which should be 5 stud x 112 and the centre bore is the same they’re fine. I think centre bore is 57.1

Fitted mine to 11 plate. No problems either with the offset. I’ll ping a photo over at some point.

Also I checked Speedo with a couple of iPhone apps before and after and made around 1mph difference but I was 4mph out anyway (under obviously)

Along as the rolling diameter is less than 1% I think they’re normally ok. I remember I checked this myself and I think the rolling diameter was just under 1%. Just make sure you get the right tyres


Sent from my iPhone using Tapatalk

Re: turbine wheels

Posted: Wed Nov 24, 2021 6:05 pm
by Cabman
thanks for that mate id like to see a pic if possible :D

Re: turbine wheels

Posted: Wed Nov 24, 2021 6:58 pm
by Giddy
I'm fairly sure it's quite a few of them and lots of others in Caddy alloy thread https://www.caddy2k.com/forum/viewtopic.php?f=12&t=797

Re: turbine wheels

Posted: Wed Nov 24, 2021 7:08 pm
by Vertex92
Appreciate it’s dark will take another tomorrow Image


Sent from my iPhone using Tapatalk

Re: turbine wheels

Posted: Wed Nov 24, 2021 7:14 pm
by Vertex92
Here’s the code for what I fitted
3C8 601 025
8.0Jx18H2 Image


Sent from my iPhone using Tapatalk

Re: turbine wheels

Posted: Thu Nov 25, 2021 2:28 pm
by Pinnacle100
19’s on mine and they are fine Image


Sent from my iPhone using Tapatalk

Re: turbine wheels

Posted: Thu Nov 25, 2021 2:31 pm
by Vertex92
Here’s a link I found useful for checking rolling diameters

https://alloywheels.com/tyreCalculator


Sent from my iPhone using Tapatalk