Page 745 of 1030
Re: What did you do to your van today?
Posted: Tue May 19, 2020 11:16 pm
by Hardknocks
@R8umar
That looks smart dude.
Sent from my SM-G981B using Tapatalk
Re: What did you do to your van today?
Posted: Wed May 20, 2020 8:37 am
by Dickiefree
R8umar"]Spiced up the engine cover
I’m really liking that, great job
Sent from my iPhone using Tapatalk
Re: What did you do to your van today?
Posted: Wed May 20, 2020 11:09 am
by Jca730
New tyre day for me as the front tyres had badly worn on the inside edge, tracking was well out so now that's been sorted too. Nice to have a steering wheel that's dead centre again
Sent from my ANE-LX1 using Tapatalk
What did you do to your van today?
Posted: Wed May 20, 2020 11:23 am
by C Chis
PTC heater install for me today!
Managed to pick up a PTC heater (rev E) wiring and fuse yesterday for the rather modest sum of £15, result!
It’s not the easiest of things to install, took 3 hours, a bit of cursing and a little bit of skin!
Testing with VCDS, all working, lots of hot air coming out the vents, test mode doesn’t seem to run the heater at full power, it got significantly hotter when I stopped the test and let it run!
Still have an error code that I can’t remove, bummer
And the cables are nice and cool, no heating up of the cables or connections.
Bring on the cold and frosty mornings!
Sent from my iPad using Tapatalk
Re: What did you do to your van today?
Posted: Wed May 20, 2020 11:40 am
by Taher
Try this.
Start up your vehicle. Whilst it's stationary and in neutral, turn the steering full lock to the left (possibly hold it for a second) and then to the opposite side. This may clear the fault code.
Good luck !!!
gazza31112 wrote: ↑Sun May 17, 2020 12:23 pm
I tried to clear mine but it just comes back, apparently from what I have read the sensor needs recalibrating, you can only refill the amount it says on the dash, I just filled until it overflowed, which apparently confuses the sensor.
Not certain of this, it's just what Iv read.
I haven't bothered to get it checked as my warranty has just run out lol, Iv got a fault code of failure to read NOX sensor b, I assume that's something to do with adblue, but still runs fine.
Sent from my J8210 using Tapatalk
Re: What did you do to your van today?
Posted: Wed May 20, 2020 3:22 pm
by Papa Bear
Been getting very hot refitting my front headlining and trims after finishing off painting.
The dreaded A pillars to do. Ordered black grab handles as don’t fancy painting them and going to make new loops for the grab straps. Just the seat belt top covers to paint then start on the rear ones. Will take pics tomorrow when A pillars are in.
Re: What did you do to your van today?
Posted: Wed May 20, 2020 4:52 pm
by Doc
From memory those seat belt top covers are not very expensive for all the parts new and in black.
Sent from my IN2023 using Tapatalk
Re: What did you do to your van today?
Posted: Wed May 20, 2020 5:10 pm
by RY_VW
@Hardknocks do you know I thought it was but for some reason I wasnt 100%
good choice does it only cone out in summer?
Re: What did you do to your van today?
Posted: Wed May 20, 2020 5:44 pm
by Mattyh606
@R8umar nice carbon fella
Sent from my SM-N976B using Tapatalk
Re: What did you do to your van today?
Posted: Wed May 20, 2020 5:55 pm
by Papa Bear
@doc, thanks, will go part number searching
Re: What did you do to your van today?
Posted: Wed May 20, 2020 6:00 pm
by Giddy
All the black bits are in the useful part numbers thread
https://www.caddy2k.com/forum/viewtopic ... &start=180
Re: What did you do to your van today?
Posted: Wed May 20, 2020 6:01 pm
by Papa Bear
@giddy, that’s what I was looking for, remembered seeing it before
Thanks
Re: What did you do to your van today?
Posted: Wed May 20, 2020 6:03 pm
by Giddy
No worries mate
Re: What did you do to your van today?
Posted: Wed May 20, 2020 8:34 pm
by DeanWhit
Re: What did you do to your van today?
Posted: Wed May 20, 2020 9:43 pm
by Stedlocks
I liked the other rims too....but they look good!