CADDY2K.com

So go a lot done 2day slowly getting there so the rear axle is up marked up where the coil overs are going and got the fuel take up still a lot to do but we are getting there

Sent from my SM-G950F using Tapatalk

It's coming together now James.
Can't wait until you finish this one

Neither can I lol when all the cutting and welding is done I've got drop it all to seam seal it and paint it and then strip the rear subframe down to get it all painted and rebuilt with all my new parts just gota wait on my turret tops to be done was hoping to have them yesterday but they didn't get time to do them so can't do much more till they are done

Sent from my SM-G950F using Tapatalk

There’s some serious graft gone into James, no doubt it’ll be impressive and worth the wait


Sent from my iPhone using Tapatalk

This is an impressive project and some really good skills too!

Thanks guys I'm learning a lot as I go with this and bout the caddy's you never stop learning lol

Sent from my SM-G950F using Tapatalk

Looking good mate.


Sent from my iPhone using Tapatalk

Just a quick updates just got back from London picking up a Tiguan fuel tank for the caddy I no I have fitted the golf 4motion tank but I wasn't happy with it so I've been doing a bit of research and it help with having one in at work but measuring up the Tiguan fuel tank and the measurements of the space on the caddy it should fit lovely so I off down the unit now to see How it fits will post photos and updates later 2night

Sent from my SM-G950F using Tapatalk

Ok well the rear tank is the new one and the font one is the golf as you can see it smaller I've put it up and it is loads better much happyer with it still I've gota do a bit of cutting and welding as there is a cross member in the way what I'll do is cut it out order a new one from TPS and weld it in in a different place so that's the plan I hope lol

Sent from my SM-G950F using Tapatalk

So started fitting the fuel tank and getting that sitting correctly be for I finish off the welding and start seam sealing. so the mounts are spotted on and technically bolted in just put the axle stand under to hold it until I finish welding and putting the straps on. fuel tank sits nice now had to adjust the floor a bit as on the back of the tank it has a breather and the lugs it sits on also had to do it because I wasn't happy with how low it sat.ive gota get some fuel pipes made up what I'll do at work so no Biggie next is to sort out suspension turret tops and fuel filler neck once that's done then it's a little bit of tidying up a bit of welding then on to seam sealing

Sent from my SM-G950F using Tapatalk

Very interesting build that i will most certainly continue to follow.

Keep up the hard graft lad

MOR90 wrote:Very interesting build that i will most certainly continue to follow.

Keep up the hard graft lad

Thanks

Sent from my SM-G950F using Tapatalk

Your welcome man

Making good progress. Hope it all come together nicely.


Sent from my iPhone using Tapatalk

So been doing a bit after work this week and now the tank is done as far as mounting anyway so dropping the tank now and can start seem welding the brakets and finishing put in the New Cross members.

Sent from my SM-G950F using Tapatalk