Hey guys.
New to the website, wish I would've discovered this treasure trove before I'd finished this.
What do you think?
My first attempt at any kind of mods in a vehicle.
Sent from my CLT-L09 using Tapatalk
Rate my insulating and lining
-
- Caddy2k Groupie
- Posts: 15
- Joined: Fri Jun 04, 2021 9:08 am
- Engine size/power: 1.6 CR TDI (75bhp)
-
- Caddy2k Groupie
- Posts: 10
- Joined: Tue Nov 17, 2020 10:54 pm
Re: Rate my insulating and lining
Kingspan and expanding foam is usually a better choice when insulating vans but looks ok.
Just keep an eye on it for condensation build up, as Sitting water will rust it fairly quickly.
Just keep an eye on it for condensation build up, as Sitting water will rust it fairly quickly.
-
- Caddy2k Groupie
- Posts: 15
- Joined: Fri Jun 04, 2021 9:08 am
- Engine size/power: 1.6 CR TDI (75bhp)
Re: Rate my insulating and lining
Thanks for your reply.
I have been keeping an eye on it, I have a roof vent though so think that helps alot.
Cheers
Sent from my CLT-L09 using Tapatalk
I have been keeping an eye on it, I have a roof vent though so think that helps alot.
Cheers
Sent from my CLT-L09 using Tapatalk
-
- 100BHP+
- Posts: 104
- Joined: Wed Jun 02, 2021 10:59 pm
Re: Rate my insulating and lining
I'm looking to add a roof vent. Do the wind driven vents do a decent job? I'm assuming they do very little in low wind speeds.WoolvinePH wrote:Thanks for your reply.
I have been keeping an eye on it, I have a roof vent though so think that helps alot.
Cheers
Sent from my CLT-L09 using Tapatalk
Sent from my LG-H930 using Tapatalk
Caddy Maxi C20 Startline 1.6TDI 2015 Mk4 facelift
Ex BG
Ex BG
-
- Caddy2k Groupie
- Posts: 15
- Joined: Fri Jun 04, 2021 9:08 am
- Engine size/power: 1.6 CR TDI (75bhp)
Re: Rate my insulating and lining
I sat in the back for a short trip once and the draft it kicked out was alot mOre than I expected.. Stationary they don't do much to be honest when it's hit, I'm sure they do provide ventilation though from condensation and stop it getting too stuffy.
Sent from my CLT-L09 using Tapatalk
Sent from my CLT-L09 using Tapatalk
-
- Caddy2k Groupie
- Posts: 14
- Joined: Tue Sep 14, 2021 3:29 pm
- Engine size/power: 1.9 TDI (104bhp)
Re: Rate my insulating and lining
Nice job
Looking to do something similar
What was total cost of materials and did you cut ply yourself?
Looking to do something similar
What was total cost of materials and did you cut ply yourself?
-
- Caddy2k Groupie
- Posts: 15
- Joined: Fri Jun 04, 2021 9:08 am
- Engine size/power: 1.6 CR TDI (75bhp)
Re: Rate my insulating and lining
Off the top of my head.Vanny wrote:Nice job
Looking to do something similar
What was total cost of materials and did you cut ply yourself?
Ply lining kit-£120
Loft lagging - acquired for free
Silver bubble lagging - about 40 quids worth
Not a great cost and if I did it again I'd put less loft lagging in the ceiling as its bulging my ceiling. Struggled to get the pins back in but had already gone too far.
Sent from my CLT-L09 using Tapatalk
-
- Caddy2k Groupie
- Posts: 14
- Joined: Tue Sep 14, 2021 3:29 pm
- Engine size/power: 1.9 TDI (104bhp)
Re: Rate my insulating and lining
Thanks......did you buy a caddy ply kit cut to size?
-
- 100BHP+
- Posts: 104
- Joined: Wed Jun 02, 2021 10:59 pm
Re: Rate my insulating and lining
Hi,
I bought this kit, give them a call. I think they will do individual sections if you only want e.g. the side wall panels. Looking back on it my glad I bought the kit as it would have been a difficult getting side walls panels correct due to the curvature.
https://www.ebay.co.uk/itm/274908240912 ... SwRk5f0WHX
I bought this kit, give them a call. I think they will do individual sections if you only want e.g. the side wall panels. Looking back on it my glad I bought the kit as it would have been a difficult getting side walls panels correct due to the curvature.
https://www.ebay.co.uk/itm/274908240912 ... SwRk5f0WHX
Caddy Maxi C20 Startline 1.6TDI 2015 Mk4 facelift
Ex BG
Ex BG