Page 2 of 2

Re: Murphy’s White Mk4

Posted: Sat Mar 15, 2025 8:41 pm
by Mk4Murphy
Finally got the van back on road after injector failure managed to get on warranty though so a few pennies saved so back to work on bits today

Stripped out the passenger side carpet again & sound insulated the footwell

Image

Then cleaned up & fitted the Touran base I picked up Image

Then I connected up the looms from stan the man & fitted the sirroco seat

Ran out of daylight today so one down other side tomorrow :D

Image

Re: Murphy’s White Mk4

Posted: Sun Mar 16, 2025 5:58 pm
by Mk4Murphy
Other side done now

Discovered a bit of rust around accelerator pedal anchor doobry firkin (as dte would say) so sanded it back & hit with a bit of primer to try inhibit rust. Stuck down the dodo mat

Image

Then in with the carpet
Image

The finished job

Image

Quite chuffed with how it’s turned out. I’ve got some left over sound insulation so going to be used to make a start in load area & put in some interior light leds from Vanstyle while I was at it.

What’s next then :roll:

Re: Murphy’s White Mk4

Posted: Sun May 04, 2025 8:30 pm
by POTTERINDIUMMK4
Nice! Did the dodo matt make much difference? The cab floor in roof in all thats left for me to deaden on mine....