CADDY2K.com

Spent a best part of the day fitting CSR spoiler. What a pain in the arse to line everything up properly. Hopefully I don't have to do anything similar any time soon

Can't wait to see it in a daylight now

Very cool mate, top work as always.


Sent from my iPhone using Tapatalk

Looks good buddy


Sent from my iPhone using Tapatalk

Thanks lads
Couple more daylight shots. Very pleased how it's turned out

Looks great dude, really liking that!


Sent from my iPhone using Tapatalk

Smart as buddy where did you take live for cigarette lighter in the rear of the van mate and is that permanently live?

Sent from my SM-G988B using Tapatalk

Thanks mate. I've added an extra feed from the fuse box. It is permanent live.
How to is in the link https://www.caddy2k.com/forum/viewtopic ... 22&t=33096
Also, if you need a plug and play solution, you can drop @tommyzooom a message, I'm sure he can make you a loom.

Such a nice van! Colour is amazing!

With your spoiler did you just bond it on, it or did you use any fixings? Looks spot on!!

Thanks mate. No fixings, some double sided tape for the initial fit and windscreen bond to keep it in place.

Only a small upgrade, but these side moulding are a proper patience testers

Nice !

Do you have the partnumbers ?


Verzonden vanaf mijn iPad met Tapatalk

Yes mate, all of them are listed here https://www.caddy2k.com/forum/viewtopic ... 22&t=21017

Thnx !!

Is there a technique to removing the side mouldings, or do they just come off easily with a bit of manual persuasion & heat?

I'd say the easiest is to cut through the tape at one end using a braided fishing line or super strong thread. Then start pulling up that end slowly while heating it up. The heat helps a lot, as the double sided tape becomes softer/gooey and comes off a lot easier. Don't go crazy with the heat gun if it's not a temperature adjustable one
Then just a matter of cleaning up the tape residue with something like "tar remover". That's how I did it.