CADDY2K.com

Had a slight problem with my R32 rear calipers. The abs wire had rubbed through after touching the inside of the tyre so the warning lights had come up on the dash. This was due to the bracket being at a slightly different angle than the original caddy one. I’ve repaired the wire, re-routed it to the outside of the hand brake cable and all should be cured. While I had the jack and tools out I thought I’d take the opportunity to put 2 of my new wheels on as I hadn’t even seen what they looked like on the van since I’ve had tyres on them. Took them straight back off now until spring






Sent from my iPhone using Tapatalk

Looks the biz pal


Sent from my iPhone using Tapatalk

brooneye wrote: ↑Fri Jan 19, 2018 12:48 pm Looks the biz pal


Sent from my iPhone using Tapatalk

Cheers. You got your back yet? Im looking forward to seeing it almost as much as you are

No not yet, had some extras done and a full respray in the end. Also trying to sort modules out for new clocks.

Can’t wait to get it back as I had a sneak peak and looks good.

You got much more to do?


Sent from my iPhone using Tapatalk

Horrible waiting time

Need to get them big Brembo's fitted then maybe air ride In the meantime, my water pump is leaking so it's having that, the cam belt and oil service done next week.

Can't wait untill summer..wheels are stunning!

Been slowly accumulating all the necessary parts for the 6 pot brake upgrade. Will dry fit everything when I get a chance just to make sure it all fits, then all being well I’ll put them on permanently sometime in the next couple of weeks.

Thanks to Slipperjake for all the advice with parts







Size of them pads





Sent from my iPhone using Tapatalk

Very jealous! Can't wait to see this all in place.

looks like you'ii some serious stopping power with them - brick wall stoppers - looks like they will fill the wheel - tempting mmm ?

Looking good! pads were ok then?


Sent from my iPhone using Tapatalk

Seems to be all going together nicely mate yeah Just need to dry fit the calipers to the van to make sure the bolts fit as they should.

They look real nice pal


Sent from my iPhone using Tapatalk

Well you know what I think.


Sent from my iPhone using Tapatalk

I do like these a lot - what are they off ? Disc size ? Making me think they would be just about right to stop a maxi with more than the average power upgrade

the long one wrote: ↑Sat Jan 27, 2018 6:43 pm I do like these a lot - what are they off ? Disc size ? Making me think they would be just about right to stop a maxi with more than the average power upgrade

Calipers are off a Porsche Cayenne, VW Toureg, Audi Q7. Discs are 350mm from a Mercedes ML.