Re: Taddy TFSI
Posted: Sun Feb 15, 2015 9:51 pm
Its a MK5 edition 30 splitter grafted onto the toucan bumper and blended in.gogsie wrote:Like that a lot. The front end goes well with the black, what splitter is on it?
Page 5 of 6
Re: Taddy TFSI
Posted: Sun Feb 15, 2015 10:23 pm
Looking awesome, bud. You're paintwork is like mine! 
Jonesy
Jonesy
Re: Taddy TFSI
Posted: Wed Mar 25, 2015 6:53 pm
Re: Taddy TFSI
Posted: Mon Mar 30, 2015 6:58 am
Wow you is a genius! All them frickin wires!! Great van I bet it flys.
Re: Taddy TFSI
Posted: Thu Apr 30, 2015 9:25 pm
Custom Fabricated 3" Exhaust on the Taddy. Think it might be a bit noisy for my liking.
https://youtu.be/u0xrRNkFfsE
https://youtu.be/u0xrRNkFfsE
Re: Taddy TFSI
Posted: Thu Apr 30, 2015 9:32 pm
That sounds awesome!
Re: Taddy TFSI
Posted: Thu Apr 30, 2015 9:34 pm
Sounds great, any pics of the exhaust?
Re: Taddy TFSI
Posted: Thu Apr 30, 2015 9:54 pm
Only got some pics of it on the floor. I was trying to keep it stealth but think I am going to have to change it up a bit. You can't see the exhaust from the back of the van, it is following the existing route and is then slash cut towards the ground. The problem is because it doesn't protrude past the rear bumper you get loads of drone at motorway speeds which is really annoying. I was pretty sure that it would happen but wanted to try it out to keep it stealth. I will probably have to be modded to go through the back bumper which I was trying to avoid.
The backback elbow is not slash cut in the picture, that has now been cut.
The backback elbow is not slash cut in the picture, that has now been cut.
Re: Taddy TFSI
Posted: Thu Apr 30, 2015 10:20 pm
Sounds awesome
Re: Taddy TFSI
Posted: Thu Apr 30, 2015 10:34 pm
Could you put a turn towards the side so it's still stealthy but exits out under the bumper if that makes sense. I've heard of droning issues when having the exhaust facing the ground. Looking forward to hearing mine tomorrow now!
Re: Taddy TFSI
Posted: Thu May 07, 2015 10:13 pm
Think I'm going to play around with some different backbones to calm the noise down. I built the van to drive, and with those noise levels its going to attract too much unwanted attention. Its just a getting a balance between the noise and exhaust restriction.
Re: Taddy TFSI
Posted: Thu Dec 31, 2015 1:57 pm
I cant pm anyone yet as im new to the forum is there any chance you could share some of your knowledge on this conversion with me
Re: Taddy TFSI
Posted: Thu Dec 31, 2015 3:36 pm
Nice big kudos for having the balls to do all that mate.I remember putting an rs turbo engine in an xr3 was a mare this would blow my mind 
Re: Taddy TFSI
Posted: Thu Dec 31, 2015 4:39 pm
What do you need to know?
Re: Taddy TFSI
Posted: Fri Jan 01, 2016 10:03 pm
Nice work.
The painted covers of the bumper grill will fit on the original touran bumper grils?
The painted covers of the bumper grill will fit on the original touran bumper grils?