CADDY2K.com

I trimmed off both of the thin sections left and right of the bulkhead which have the mounting points. A Dremel would probably be more precise but I just used a hacksaw and left enough material to sand and smooth down to a decent finish. The tricky bit is following the contours at front and back of the bulkhead to make sure you don’t cut off too much material.
I then carpeted the trimmed sections and mounted them using the existing holes and bolts.
I found a decent guide posted here with pictures http://forum.caddy2k.com/viewtopic.php? ... 85287b74bc


I didn’t know about the CaddyLife upper and lower B pillar trims you can get from VW till afterwards, but it’s a cheaper alternative looks the part I think

Cheers dude

Door cards arrived today! They’re in pretty good condition as per the listing. Once the switches are replaced, lining re-trimmed and given a good scrub they should look good

Still sifting through the part numbers to figure out what motors, control modules & loom I need for electric windows

JD2k wrote:Door cards arrived today! They’re in pretty good condition as per the listing. Once the switches are replaced, lining re-trimmed and given a good scrub they should look good

Looking good JD really enjoying watching this build take place

Sent from my SM-G950F using Tapatalk

What year is your caddy? I’ve got my door cards off at the minute so I can give you the part numbers of mine and you can check to see if they are ok for what your doing


Sent from my iPhone using Tapatalk

caddychris2002 wrote:Looking good JD really enjoying watching this build take place

Sent from my SM-G950F using Tapatalk

Thanks mate still got quite a bit more to do but getting there slowly


Sent from my iPhone using Tapatalk

brooneye wrote:What year is your caddy? I’ve got my door cards off at the minute so I can give you the part numbers of mine and you can check to see if they are ok for what your doing


Sent from my iPhone using Tapatalk

I’ve got a 2012 caddy so facelift model.. cheers it’ll be good to check against the part numbers that I’ve come across

Caddyluv wrote:Behave. £50 stereo surround and 4 door bump strips. Sanded and painted.


Sent from my iPhone using Tapatalk

Where from mate you got a link please ?

Sent from my VTR-L09 using Tapatalk

Here’s my modules, you’ll have double check

Passenger



Drivers




Sent from my iPhone using Tapatalk

Thanks for the part numbers much appreciated! Just to confirm, does your driver's side motor have the same part number 1T0959701?

Did a quick search using http://www.oemepc.com and found:

PASSENGER
1T0959701 - MOTOR 2005-2007
1K0959792 - CONTROL MODULE 2004-2016
DRIVERS
1K0959793 - CONTROL MODULE 2004-2016

Looks like the control modules will work, but possibly not the motors so I'll have to look further into that one.

Had another look.. it seems like the following motors are compatible with those control units for a 2012 caddy:

PASSENGER
1T0959702 - MOTOR 2009-2016
1K0959792 - CONTROL UNIT 2004-2016
DRIVERS
1T0959701 - MOTOR 2009-2016
1K0959793 - CONTROL UNIT 2004-2016

Got hold of some touran motors with control units for £20 each.. hopefully they’ll work

Bit of work done on the centre console.. added an internal USB/AUX port

Then shortened the rear panel.. will be adding a switch panel at the bottom for lights/USB sockets/Voltmeter display running off the leisure battery