CADDY2K.com

A short video of some light shifting!!

https://youtu.be/IC8P1-xez2s?si=Xenrk1XL7Pfxww0E


Sent from my iPhone using Tapatalk

Pineapple1984 wrote: ↑Sun Nov 05, 2023 7:36 pm A short video of some light shifting!!

https://youtu.be/IC8P1-xez2s?si=Xenrk1XL7Pfxww0E


Sent from my iPhone using Tapatalk

Mega stuff this!

Sent from my SM-G973F using Tapatalk

Loving the DSG shifts, I’ll need to get my finger out and get mine swapped over from manual to auto!

Good progress!


Sent from my iPad using Tapatalk

UH OH!!!!
That’s not the fault code you want appearing on a VR6 engine. I’m sure the chains were good on this last time I had the Audi in. Suppose that was a while ago. My own fault should of done them before it went in.

Oh well back out again then


Sent from my iPhone using Tapatalk

And this turned up today
But that will have to wait for now!


Sent from my iPhone using Tapatalk

Ah that's a nightmare ladbut I suppose once it's done it donewhat goodies did u get in the box

Sent from my SM-G973F using Tapatalk

Induction kit! Try and make the most of all this noise


Sent from my iPhone using Tapatalk

That's true

Sent from my SM-G973F using Tapatalk

This wiring loom mate is that from the a3 fuse box to ecu?

Sent from my SM-G973F using Tapatalk

Hi @Damo, That’s basically the whole Audi loom excluding the engine wiring loom

Ah rite did u use most of that?

Sent from my SM-G973F using Tapatalk

Not that much to be honest I basically started with the ECU Main plug and then followed each wire to the designation, de pinned and tagged it.


Sent from my iPhone using Tapatalk

Ah rite got ittought for a sec u did complete full loom swap..could it be done without that loom?would the caddy ecu plug fit the a3 ecu and just depin and splice them?

Sent from my SM-G973F using Tapatalk

Also when in vw erwin all I am seeing is diagrams for current flowam I missing something as cannot seem to locate the pinout diagrams.

Sent from my SM-G973F using Tapatalk