CADDY2K.com

No worries at all mate.


Sent from my iPhone using Tapatalk

Hi there ? For you when you did the additional door seals did you go right round the door and it looks like about the 12mm size is that correct thanks for your time Gary

Hi mate yeah right round the door with the join on the lower edge, remember to put drain holes through the seal at the front on rear otherwise you will collect water on your sill. I used 14mm D seal on mine.


Sent from my iPhone using Tapatalk

Hi thanks for replying when you say on the rear do you mean the sliding door been looking at mine ( I have a maxi ) and not really sure where to put the extra seal have you got a pic of yours thanks Gary

Hi mate, no on the front door (I haven’t done the sliding door ) but the front the rear corners on the lower section (where they touch the sill). I’ll try and remember to get some photos at the weekend as the van isn’t currently at my house.


Sent from my iPhone using Tapatalk

Cheers appreciate that

Looks as good as mine lol how did you find doing them with the lines ?

Sent from my SM-G950F using Tapatalk

Ha ha, the first one wasn’t too bad, I drew parallel lines on the rear foam which I aligned with the top of the handle recess. The second however was a pain in the arse trying to get the spacing to match the first. I think the vertical lines are off slightly, but I still need to put it back together so will see how it looks tonight. Cheers for pointing me where to get the factory material.


Sent from my iPhone using Tapatalk

Lovely van, the changes you've made are really done well.

Lister79 wrote:Ha ha, the first one wasn’t too bad, I drew parallel lines on the rear foam which I aligned with the top of the handle recess. The second however was a pain in the arse trying to get the spacing to match the first. I think the vertical lines are off slightly, but I still need to put it back together so will see how it looks tonight. Cheers for pointing me where to get the factory material.


Sent from my iPhone using Tapatalk

No problem mate we are all here to help each other out yes I had the same problem but in the end it come out looking good

Sent from my SM-G950F using Tapatalk

Drivers side finished, unfortunately vertical lines are in a slightly different position to the passenger side (was concentrating too much on getting the horizontal lines straight ), but I still think it looks ok so I’ll be leaving it, and if you wave your phone about while looking at the photos you’ll never notice .














Sent from my iPhone using Tapatalk

Looks good pal


Sent from my iPhone using Tapatalk

Cheers mate. Hoping to have it on the road 1st March, I’m both excited and dreading it as there isn’t a spec of dirt on it at the minute.


Sent from my iPhone using Tapatalk

Is there much left to do on it?


Sent from my iPhone using Tapatalk

No not really A5 side skirts to fit, possibly windows to tint slightly then just little bits and continue with the polishing.


Sent from my iPhone using Tapatalk