Hampshire Caddy
- Papa Bear
- Hyper Poster
- Posts: 1885
- Joined: Sun Mar 01, 2020 10:44 pm
- Engine size/power: 1.6 CR TDI (102bhp)
- Location: Hampshire, UK
Re: Hampshire Caddy
Forgot wheels
And possibly lowering a little as I hate the gap above the wheels
And possibly lowering a little as I hate the gap above the wheels
Caddy Maxi Life 1.6TDI 7 speed DSG 102bhp
Black
Marmite lover!!!
VCDS
Black
Marmite lover!!!
VCDS
- C Chis
- Hyper Poster
- Posts: 1657
- Joined: Fri Mar 06, 2020 1:13 pm
Re: Hampshire Caddy
and the list gets longer....
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
2010 pre-facelift Mk3 3.2 VR6 : Touran Interior : 3D Premium Clocks : R32 Bumper : Climatic A/C
My VR6 Build Thread and Details can be Found Here
My VR6 Build Thread and Details can be Found Here
- Papa Bear
- Hyper Poster
- Posts: 1885
- Joined: Sun Mar 01, 2020 10:44 pm
- Engine size/power: 1.6 CR TDI (102bhp)
- Location: Hampshire, UK
- Papa Bear
- Hyper Poster
- Posts: 1885
- Joined: Sun Mar 01, 2020 10:44 pm
- Engine size/power: 1.6 CR TDI (102bhp)
- Location: Hampshire, UK
Re: Hampshire Caddy
Learning VCDS
Ran wires for the PTC heater and soldered into the CANBUS, can’t connect it yet as missing the bolt to attach to the fuse.
Fitted the battery box as I had the battery out, jus5 need to ge5 a lid for it now.
Battery reconnected and had lots of dash lights. Bulb, steering, traction.
VCDS arrived half hour later luckily. Ran scan, cleared codes, showing steering angle sensor fault.
Did a Steering Limit Stop Adaptation, all lights gone off
Going out to play with VCDS later to check any faults left, change indicator blink to 5 not 3, enable needle sweep , set DRL’s off when hand brake is on and unlock all doors from one press off unlock on keyfob (not found out how to do the last one yet).
Scrap yard trip tomorrow, and if nothing else, getting another bloomin fuse bolt
Ran wires for the PTC heater and soldered into the CANBUS, can’t connect it yet as missing the bolt to attach to the fuse.
Fitted the battery box as I had the battery out, jus5 need to ge5 a lid for it now.
Battery reconnected and had lots of dash lights. Bulb, steering, traction.
VCDS arrived half hour later luckily. Ran scan, cleared codes, showing steering angle sensor fault.
Did a Steering Limit Stop Adaptation, all lights gone off
Going out to play with VCDS later to check any faults left, change indicator blink to 5 not 3, enable needle sweep , set DRL’s off when hand brake is on and unlock all doors from one press off unlock on keyfob (not found out how to do the last one yet).
Scrap yard trip tomorrow, and if nothing else, getting another bloomin fuse bolt
Caddy Maxi Life 1.6TDI 7 speed DSG 102bhp
Black
Marmite lover!!!
VCDS
Black
Marmite lover!!!
VCDS
- Papa Bear
- Hyper Poster
- Posts: 1885
- Joined: Sun Mar 01, 2020 10:44 pm
- Engine size/power: 1.6 CR TDI (102bhp)
- Location: Hampshire, UK
Re: Hampshire Caddy
Cruise control installed and coded, air bag took longer to get off than the whole rest of the job!
Indicators now flash 5 times
Still haven’t worked out how to do a needle sweep and the trip buttons on the wiper stalk don’t work yet.
Indicators now flash 5 times
Still haven’t worked out how to do a needle sweep and the trip buttons on the wiper stalk don’t work yet.
Caddy Maxi Life 1.6TDI 7 speed DSG 102bhp
Black
Marmite lover!!!
VCDS
Black
Marmite lover!!!
VCDS
- C Chis
- Hyper Poster
- Posts: 1657
- Joined: Fri Mar 06, 2020 1:13 pm
Re: Hampshire Caddy
Awesome!
Double check your SWCM, midline ones will code in for cruise control but not the trip function.
I have a highline SWCM but only a lowline instrument cluster so don’t get MFD
Sent from my iPad using Tapatalk
Double check your SWCM, midline ones will code in for cruise control but not the trip function.
I have a highline SWCM but only a lowline instrument cluster so don’t get MFD
Sent from my iPad using Tapatalk
2010 pre-facelift Mk3 3.2 VR6 : Touran Interior : 3D Premium Clocks : R32 Bumper : Climatic A/C
My VR6 Build Thread and Details can be Found Here
My VR6 Build Thread and Details can be Found Here
- C Chis
- Hyper Poster
- Posts: 1657
- Joined: Fri Mar 06, 2020 1:13 pm
Re: Hampshire Caddy
Needle sweep
Have a look in 17, instruments then under one of the drop down options in adaptation for celebration. Should be in there somewhere
Sent from my iPad using Tapatalk
Have a look in 17, instruments then under one of the drop down options in adaptation for celebration. Should be in there somewhere
Sent from my iPad using Tapatalk
2010 pre-facelift Mk3 3.2 VR6 : Touran Interior : 3D Premium Clocks : R32 Bumper : Climatic A/C
My VR6 Build Thread and Details can be Found Here
My VR6 Build Thread and Details can be Found Here
- Papa Bear
- Hyper Poster
- Posts: 1885
- Joined: Sun Mar 01, 2020 10:44 pm
- Engine size/power: 1.6 CR TDI (102bhp)
- Location: Hampshire, UK
Re: Hampshire Caddy
Thank you, will peruse later when trying to get trip computer working. Making dinner at the mo
Caddy Maxi Life 1.6TDI 7 speed DSG 102bhp
Black
Marmite lover!!!
VCDS
Black
Marmite lover!!!
VCDS
- Papa Bear
- Hyper Poster
- Posts: 1885
- Joined: Sun Mar 01, 2020 10:44 pm
- Engine size/power: 1.6 CR TDI (102bhp)
- Location: Hampshire, UK
Re: Hampshire Caddy
Updated list
Blanks in wiper scuttle DONE
reversing camera DONE (but may change as pointing too low)
Dye headlining DONE
paint beige trims DONE
install switch panel DONE
run wires for video etc DONE
blue led headlining lights DONE
headlining light board DONE
Battery box DONE
Cruise control DONE
PTC heater DONE
Trip computer (needs enabling)
Engine cover
Detail engine bay
TV (need to find one, all wiring done)
Cruise control (bought but not fitted)
Heated seats
Footwell lights
Replace cracked brake light
Tinted tail lights (film failed, got spray to try)
Tow bar
Bodywork (scratches on NSR, stone chips, bumper crazed)
Jump boot bed (half built)
Leisure battery
MFSW
Blue needles and LED’s
Wheels
Lowering
A few coding changes when I can get my hands on VCDS
DRL’s off with handbrake on
Needle sweep
Indicator flash 3 to 5 DONE
Blanks in wiper scuttle DONE
reversing camera DONE (but may change as pointing too low)
Dye headlining DONE
paint beige trims DONE
install switch panel DONE
run wires for video etc DONE
blue led headlining lights DONE
headlining light board DONE
Battery box DONE
Cruise control DONE
PTC heater DONE
Trip computer (needs enabling)
Engine cover
Detail engine bay
TV (need to find one, all wiring done)
Cruise control (bought but not fitted)
Heated seats
Footwell lights
Replace cracked brake light
Tinted tail lights (film failed, got spray to try)
Tow bar
Bodywork (scratches on NSR, stone chips, bumper crazed)
Jump boot bed (half built)
Leisure battery
MFSW
Blue needles and LED’s
Wheels
Lowering
A few coding changes when I can get my hands on VCDS
DRL’s off with handbrake on
Needle sweep
Indicator flash 3 to 5 DONE
Caddy Maxi Life 1.6TDI 7 speed DSG 102bhp
Black
Marmite lover!!!
VCDS
Black
Marmite lover!!!
VCDS
- the swan fiend
- Hyper Poster
- Posts: 5151
- Joined: Sat Feb 18, 2017 10:52 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Hampshire Caddy
Sounds like you’re getting to grips with VCDS quickly mate.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Rescue me from the swans in me
- Papa Bear
- Hyper Poster
- Posts: 1885
- Joined: Sun Mar 01, 2020 10:44 pm
- Engine size/power: 1.6 CR TDI (102bhp)
- Location: Hampshire, UK
Re: Hampshire Caddy
Wouldn’t go that far
Still a few things to do and then loads more to learn
Fun though
Still a few things to do and then loads more to learn
Fun though
Caddy Maxi Life 1.6TDI 7 speed DSG 102bhp
Black
Marmite lover!!!
VCDS
Black
Marmite lover!!!
VCDS
- the swan fiend
- Hyper Poster
- Posts: 5151
- Joined: Sat Feb 18, 2017 10:52 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Hampshire Caddy
I can imagine mate. I’d be a bit worried I’d do damage with one. You never know, I may take the plunge one day.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Rescue me from the swans in me
- Papa Bear
- Hyper Poster
- Posts: 1885
- Joined: Sun Mar 01, 2020 10:44 pm
- Engine size/power: 1.6 CR TDI (102bhp)
- Location: Hampshire, UK
Re: Hampshire Caddy
Doing an auto scan every time just in case, making notes of what I change and triple checking here before changing
Sorry if everyone gets fed up with my questions
I’ve got some errors that were there originally that I need to sort, will be requesting help with those.
One is because it’s got a non oem stereo which is fair enough but another is to do with my dsg box which is a worry.
Sorry if everyone gets fed up with my questions
I’ve got some errors that were there originally that I need to sort, will be requesting help with those.
One is because it’s got a non oem stereo which is fair enough but another is to do with my dsg box which is a worry.
Caddy Maxi Life 1.6TDI 7 speed DSG 102bhp
Black
Marmite lover!!!
VCDS
Black
Marmite lover!!!
VCDS
- the swan fiend
- Hyper Poster
- Posts: 5151
- Joined: Sat Feb 18, 2017 10:52 pm
- Engine size/power: 1.6 CR TDI (102bhp)
Re: Hampshire Caddy
Yeah, making a note of any settings you change can get you out of a whole load of trouble!!
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Rescue me from the swans in me
- Doc
- Not God, just a bellend
- Posts: 18492
- Joined: Thu Jan 01, 1970 1:00 am
- Engine size/power: 2.0TSI EA888 Gen3
- Location: Monaghan, Ireland & Derbyshire, UK
Re: Hampshire Caddy
Making notes is not as good as getting used to using the system you've bought and learning how to go to the Ross-tech/VCDS/Debug/CodingLog.CSV for a full run down of every thing you've used it for.
It's invaluable.
There's also an adaptions log in there if you do change any adaptions.
It's invaluable.
There's also an adaptions log in there if you do change any adaptions.
2013 Caddy with EA888 Gen3 2.0TSI DSG, Superplus MSP19 , Caddy4 rear lights, Polo GTI (mk7 style) steering wheel, Relentless Tuning front coilovers, Audi A6 S-Line front seats, Boxster fronts & GTI rear Brakes, 3D Colour Premium dash cluster, Caddy life arm rest, Motexion bulkhead, MIB head unit
All posts written by me are the intellectual property of the caddy2K forum and I do not consent to copying or redistribution of any sort