CADDY2K.com

Hi guys I'm putting halo rings in my caddy headlights I know they go to the side lights but on the side lights there both black wires halos red and black witch wire goes where on the sidelights thanks



Sent from my SM-G965F using Tapatalk

How out of interest did you get on fitting these in and splitting the light as I want to do this

Bit off a pain splitting them best off with a heat gun halos you need is 100mm and 120mm

few ways you can find out. if you have a bench power supple set it to 12v @ 0.2A (200MA) - attach the wire and see if the glow. then note the polarity.

multi-meter in diode more and check wires you should get a reading with the correct polarity. and if not correct you will get 0 reading.

Where did you get them from please , are they specifically wired into the sidelights only

https://www.amazon.co.uk/Qasim-1-Pair-S ... 9253&psc=1

Yes wire them into your sidelights

Thanks mate il look at getting some of these , I have the touran black 4 pot lights currently so may be worth practicing on a cheap light from a scrappy.
Is it just gentle heat around the seal ?

Yes not red hot otherwise you will melt the plastic just take it easy and don't rush it I've done them on my 4 pod

I definitely will try it last question is do you have to remove the bumper to remove the headlight as I had the garage fit them , thanks for your help mate

Yes pal need remove the bumper to get to the screws it's easy enough to do

Top man many thanks

No worries

this sounds a great idea, id love to see the finished article!

Halos all done



Sent from my SM-G965F using Tapatalk

Morning all, what wires from the side lights to the halo's need to be used?
Cheers....