Spent the best part of my day chopping up my dash to fit a touran glove box in. Much prefer the look of a full panel door instead of the caddy box with van-x door and the door I did have never really fitted right. Following a few peoples threads who've done this before I somehow got away with cutting much less out of the caddy dashboard than they have.
On the dash I cut the strip out along the bottom leaving the far end holes for mounting, a small slither along the top to sit the glovebox up tight but kept the original mounting holes, a gap for the hinge on the left, and finally drilled out the spot welds on the bottom of the metal bracket down the left of the dash.
On the glove box itself I cut off all the mounting tabs down either side and the two tabs on the top then drilled new holes in the top to mount to the original holes and one on the far right at the bottom.
The airbag on/off switch of the caddy doesn't fit in the touran cutout and neither does it have the aux port my original glove box had so I cut these out of the original box in a large panel and plastic welded this in place of the touran switch.
It does fit with the door on but I have no pictures with it fitted as I've disassembled it to begin trimming. Next job is to wire up the light to interior light fuse and work out where the glove box cooler commects to

Sent from my Pixel 7 using Tapatalk