Taddy TFSI

Ollie370 · Post by **Ollie370** » Sun Feb 15, 2015 9:51 pm

gogsie wrote:Like that a lot. The front end goes well with the black, what splitter is on it?

Its a MK5 edition 30 splitter grafted onto the toucan bumper and blended in.

dubvan · Post by **dubvan** » Sun Feb 15, 2015 10:23 pm

Looking awesome, bud. You're paintwork is like mine!

Jonesy

Ollie370 · Post by **Ollie370** » Wed Mar 25, 2015 6:53 pm

Finally the weather is getting better. Just started to fit the Caddy life carpet and panels

sutton1001 · Post by **sutton1001** » Mon Mar 30, 2015 6:58 am

Wow you is a genius! All them frickin wires!! Great van I bet it flys.

Ollie370 · Post by **Ollie370** » Thu Apr 30, 2015 9:25 pm

Custom Fabricated 3" Exhaust on the Taddy. Think it might be a bit noisy for my liking.

https://youtu.be/u0xrRNkFfsE

Post by **dan@biali** » Thu Apr 30, 2015 9:32 pm

That sounds awesome!

rsjohn · Post by **rsjohn** » Thu Apr 30, 2015 9:34 pm

Sounds great, any pics of the exhaust?

Ollie370 · Post by **Ollie370** » Thu Apr 30, 2015 9:54 pm

Only got some pics of it on the floor. I was trying to keep it stealth but think I am going to have to change it up a bit. You can't see the exhaust from the back of the van, it is following the existing route and is then slash cut towards the ground. The problem is because it doesn't protrude past the rear bumper you get loads of drone at motorway speeds which is really annoying. I was pretty sure that it would happen but wanted to try it out to keep it stealth. I will probably have to be modded to go through the back bumper which I was trying to avoid.

The backback elbow is not slash cut in the picture, that has now been cut.

torque777 · Post by **torque777** » Thu Apr 30, 2015 10:20 pm

Sounds awesome

Post by **dan@biali** » Thu Apr 30, 2015 10:34 pm

Could you put a turn towards the side so it's still stealthy but exits out under the bumper if that makes sense. I've heard of droning issues when having the exhaust facing the ground. Looking forward to hearing mine tomorrow now!

Ollie370 · Post by **Ollie370** » Thu May 07, 2015 10:13 pm

Think I'm going to play around with some different backbones to calm the noise down. I built the van to drive, and with those noise levels its going to attract too much unwanted attention. Its just a getting a balance between the noise and exhaust restriction.

V4NYU · Post by **V4NYU** » Thu Dec 31, 2015 1:57 pm

I cant pm anyone yet as im new to the forum is there any chance you could share some of your knowledge on this conversion with me

jackel · Post by **jackel** » Thu Dec 31, 2015 3:36 pm

Nice big kudos for having the balls to do all that mate.I remember putting an rs turbo engine in an xr3 was a mare this would blow my mind

Ollie370 · Post by **Ollie370** » Thu Dec 31, 2015 4:39 pm

What do you need to know?

VolkswagenRacing · Post by **VolkswagenRacing** » Fri Jan 01, 2016 10:03 pm

Nice work.

The painted covers of the bumper grill will fit on the original touran bumper grils?

CADDY2K.com

Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI

Re: Taddy TFSI